Demilec Attic Insulation Nationwide

Demilec Attic Insulation: The Cypress Owner’s Guide

We stock and install Demilec-compatible spray foam attic insulation in Cypress, with most complete attic insulation jobs running between $2,400 and $6,800 depending on square footage, existing insulation condition, and whether we’re sealing the attic floor first. Most jobs are completed in a single visit, and we keep Demilec’s Heatlok HFO and Sealection 500 product lines on hand for the climate realities we see across Cypress year-round. You’ll usually discover your Demilec insulation has failed by noticing rooms that won’t hold temperature, a steady climb in your Southern California Edison bill, or finding dusty air near attic hatches and recessed lights. We’ve torn out Demilec foam in Cypress homes that looked fine from the hatch but had pulled away from the roof deck where nobody thought to look.

Call (657) 837-1179

Which Demilec Models This Applies To

Demilec makes two attic insulation product families we work with most in Cypress: Heatlok HFO (a closed-cell spray foam) and Sealection 500 (an open-cell spray foam). Each behaves differently in Southern California attics, and matching the right foam to your existing setup matters more than most contractors admit. Closed-cell Heatlok HFO runs about 2 inches per pass and acts as both insulation and air barrier, which is why we use it on roof decks and attics where we’re converting the space. Sealection 500 is open-cell, lighter, and typically used on attic floors where you just need serious thermal resistance without the higher material cost. If you have an older Demilec install from before 2015, you may have Heatlok Soy 200 or Sealection 500 from a generation that doesn’t carry the same HFO blowing agent today’s formulas use. The way to identify what you have is the label on the original install invoice or a product sticker left near the attic hatch. As an independent service provider, we stock genuine Demilec products alongside proven equivalents from Owens Corning, Icynene, and Johns Manville when the job calls for a different foam chemistry. For Cypress attics with existing Demilec open-cell that’s failed, we typically recommend the OEM material to keep things consistent rather than mixing foam chemistries that don’t bond well.

Signs Your Demilec Attic Insulation Is Failing

• Rooms directly under the attic get hot by 2 p.m. in July. This is the most common Cypress complaint we hear. Demilec foam that has shrunk or pulled away from rafters leaves gaps where radiated heat moves straight through the ceiling.
• Your energy bill has crept up 15% to 30% without adding appliances. You’re effectively air conditioning the attic. Failed or thin foam means your HVAC runs longer to hold the same indoor temperature.
• You smell attic air or dust in upper-floor rooms. Spray foam should seal the attic space. If you notice an attic smell indoors, the foam has separated, cracked, or was never sprayed thick enough in the first place.
• Visible gaps, pinholes, or cracking in the foam surface. Southern California’s UV exposure and temperature swings can make older Demilec foam brittle over time, especially on south-facing roof decks in Cypress homes.
• Rodents or insects have tunneled through the foam. We’ve pulled Demilec foam from Cypress attics that looked like Swiss cheese. Once pests create pathways, the insulation loses almost all effectiveness and needs removal and reapplication.

Replacement Cost & What’s Included

For Cypress homes, expect to budget between $2,400 and $6,800 for Demilec attic insulation removal and replacement depending on attic size, foam type, and whether we’re also air sealing the attic floor. Smaller attics in older Cypress ranch homes near Cypress College tend to land on the lower end. Larger two-story homes closer to Katella Avenue with cathedral ceilings and complex roof lines run higher. Every quote includes removal of failed foam (when needed), prep and masking, the new Demilec foam application to code depth, and cleanup. We give upfront pricing before any work starts, and the 90-Day Done Right Promise means if the application isn’t right, we come back and make it right at no charge. You can also take $50 off any repair over $250, or 5% off if you’re a senior or veteran.

DIY or Call Us?

Spray foam insulation is not a DIY product. The foam cures fast, off-ratio chemicals won’t bond, and a botched application can trap moisture in your attic sheathing and create rot or mold within one Cypress winter. What you can safely do is inspect: look for obvious gaps in coverage, check for signs of pest damage, and note whether your attic feels hotter than your living space on a mild morning. But applying or removing Demilec foam requires a trained professional with the right rig and respirator. If your foam is cracked, pulling away, or missing, give us a call at (657) 837-1179. We’ll send a uniformed, background-checked technician to look at it and give you a straight answer, no pressure.

FAQs